Two point editing does not work

Help
1

How can I choose two point editing when creating a block? It is always snapping to a rotated coordinate cross on the floor. (Is there a way to change that?)
I do not find whatˋs wrong.

1 Like
2

Hi @vr-vagabond :wave:t2:, welcome to the community! If you’re feeling social, Say Hello! 👋

To use 2 point creation you need to click the trigger instead of holding it down. Try these steps

  1. Make sure you’re in create, point your laser to your desired origin point then click once
  2. Move your controller to set the second point then click again
  3. Move your controller to set the length and height, click to complete.
3

Hi, that works. Great. Where do I find this information without asking the Community?
Many thanks.

1 Like
4

Many thanks. That works great.
Greets Joerg

1 Like
5

Our guides would be a good place to start.(2 point creation is new so our guides will need to be updated with that info)

support.arkio.is

Would be great to know if this is what you’re looking for, if not let us know what feels missing!